Digital Audio Recording With Md Recorder - Sherwood RD-7502 Operating Instructions Manual

Continued
3.
Start recording on the VIDEO 1.

DIGITAL AUDIO RECORDING WITH MD RECORDER

• Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD
recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to "CONNECTING
VIDEO COMPONENTS", "CONNECTING AUDIO COMPONENTS" and "CONNECTING DIGITAL INS and OUT" on pages
6~8 and the operating instructions of the MD recorder or CD recorder.
Notes:
• Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc.
• In most DVDs as well as some CDs, etc., digital recording may not be available depending on the signal format.
• There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of
your digital recording equipment to know what restrictions are imposed.
1.
Select the desired of CD, AUX, VIDEO 1~2 as a
recording source.
SEL
PARAMETER
TONE
TAPE
FM/AM/XM
REMOTE CONTROL RC-110
3.
Start recording on the component connected to the
OPTICAL DIGITAL OUT.
ENTER SEL
VIDEO 1 VIDEO 2
SOUND
EXT.IN
VIDEO 1 VIDEO 2 VIDEO 3
CD AUX
CD AUX
4.
Start play on the VIDEO 2 and the CD respectively.
• The audio signal from the CD and the video signal from
the VIDEO 2 will be dubbed and you can enjoy them on
the TV set and from the speakers.
Note: Be sure to observe the order of the above steps
1 and 2.
2.
For digital recording, select the digital input as recording
signal input.
D/A MODE
Note :
• When the digital signals are not input from the selected
digital input, there will be no recording.
(For details, refer to "When CD, AUX, VIDEO 1 ~ 2 is
selected as an input source" on page 16.)
4.
Start play on the desired input.
32
POWER ON STANDBY
SLEEP
2 3
1
DIMMER
6
5
D/A MODE
4
8 9
7
MUTE
P .SCAN VOLUME
0
D/A MODE CH.LEVEL
DISPLAY SETUP
SEL ENTER SEL