Sherwood RD-7502 Operating Instructions Manual page 6

2.
CONNECTING VIDEO COMPONENTS
(COMPOSITE)
VIDEO
HDMI
COMPONENT AUDIO
S-VIDEO
OUT OUT
Y C C OUT IN R L
B R
P / C
R R
P C
R / R
HDMI
(COMPOSITE)
VIDEO
COMPONENT
S-VIDEO
IN
Y C C IN
B R
• The jacks of VIDEO 1 may also be connected to a DVD recorder or other digital video recording component.
For details, refer to the operating instructions of the component to be connected.
• The jacks of VIDEO 2 can also be connected to an additional video component such as a cable TV tuner, an LD
player or satellite system.
Note :
• When Sherwood DVD player such as V-768, etc. is connected to the DIGI-LINK jack for system control, you should
connect the DVD player to the " VIDEO 2" jacks of this unit.
Because, if the PLAY button, etc. is pressed on the DVD player, the VIDEO 2 is automatically selected as an input
source on this unit. Then playback, etc. starts.
HDMI(High Definition Multimedia Interface) connection : (*)
• You can connect the source component (DVD player, etc.) to the display component (TV, projector, etc.) through this
receiver with using a commercially available HDMI cord.
• The HDMI connection can carry uncompressed digital video signals and digital audio signals.
• This receiver can output digital video and digital audio signals from the MONITOR HDMI OUT of this receiver without
passing through any circuits as they were input into the HDMI IN.
• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI
licensing LLC.
Note: Depending on the connected component, unreliable signal transfer may happen.
(For details, refer to the operating instruction of your component.)
OUT
IN
OUT
AUDIO
IN
R L
VIDEO 1 VIDEO 2
P / C Y
B B
P C Y
B / B
IN
IN
AUDIO
MONITOR OUT
6
VIDEO 1 OUT VIDEO 1 VIDEO 2
P / C P / C Y
R R B B
P / C P / C
R R B B
P C P C
R / R B / B
R L
S-VIDEO COMPONENT VIDEO
OUT HDMI
(COMPOSITE)
OUT
VIDEO
COMPONENT AUDIO
S-VIDEO
OUT OUT
OUT Y C C L R
B R
VIDEO 2
P C P C Y
R / R B / B
Y
Y