Ending Automatic Cleaning; Cleaning The Cooking Zone Manually; Preparing The Cooking Zone; Starting The Cleaning Program - Henny Penny FlexFusion PLATINUM COMBI Operation Manual

Cleaning and caring for the unit

6.11.6 Ending automatic cleaning

CAUTION
Requirements Automatic rinsing has stopped after the cleaning program was

6.12 Cleaning the cooking zone manually

6.12.1 Preparing the cooking zone

NOTICE
Requirement GN containers, baking trays and grates removed from the cooking

6.12.2 Starting the cleaning program

Requirement The unit is switched on
90
Risk of chemical burns
Droplet quantities can contain caustic constituents, so suitable protective
measures must be taken.
cancelled or the cleaning time has elapsed
1. Open the cooking zone door.
2. Remove the empty cleaning cartridge.
3. Use the hand-held shower to thoroughly rinse out any remaining
cleaner or rinsing agent.
4. Close the cooking zone door.
After the cooking zone door is closed, the cleaning program is
completed.
5. Flush away any droplets of cleaning water on the floor in front of
the unit with a soft water jet.
6. Open the cooking zone door and leave it open with a slight gap
until the unit is used again.
This extends the service life of the door seal.
No moisture builds up in the cooking zone.
Risk of property damage from improper cleaning
• Do not clean the unit with a high-pressure cleaner or water jet.
zone
1. Remove any food remains from the cooking zone.
The drain screen is not obstructed.
2. Leave only the support rack in the cooking zone in countertop
units, and leave only the tray trolley in the cooking zone in floor-
standing units.
3. Close the cooking zone door.
Tap Manual cleaning.
Operating instructions