Rear Seat; Rear Seat Cushion Cover Or Seat Back Cover; Rear Seat Cushion Assembly - Lincoln Continental 1964 Shop Manual

18-10
GROUP 18-TRIM, SEATS, AND CONVERTIBLE TOP
(370)
5. Remove the left and right front
seat back cover panels and retaining
clips.
6. Remove the left and right front
seat cushion side shield assemblies
and the shield support brackets.
7. Remove the right and left seat
backs to center arm rest frame retain-
ing screws (Fig. 3).
8. Remove 10 hog rings retaining
EJ
REAR SEAT
REMOVAL AND INSTALLATION
REAR SEAT CUSHION COVER
OR SEAT BACK COVER
I. Remove the seat cushion or
back and place on a clean bench.
HOG RINGS
A-(4 REQUIRED)
8-(13 REQUIRED)
C-(11 REQUIRED)
the seat cushion cover to the right
and left seat cushion frame.
9. Remove the right and left seat
back to seat cushion outer retaining
screws and remove the seat back as-
semblies.
10. Remove hog rings retaining
the carpet portion of the seat cushion
cover to the center arm rest frame.
11. Remove the center arm rest
2. If working on the seat back,
remove the center arm rest assembly.
3. If working on the seat cushion,
remove the heelboard cover.
4. Remove the seat cushion or
D-(21 REQUIRED ALONG BOLSTER WIRE)
E-(23 REQUIRED ALONG REAR EDGE)
F-(40 REQUIRED ALONG FRONT AND SIDE EDGES)
G-(35 REQUIRED ALONG FRONT AND SIDE)
FILLER
SPRING
REAR PAD
FIG.
&-Rear Seat Cushion Assembly
back panel to seat cushion frame
retaining screws.
12. Remove the center arm rest to
seat cushion frame retaining screws
and remove the arm rest assembly.
13. Remove the seat cushion cover
or pad from the cushion frame (Fig.
4).
14. To install the cover or pad,
reverse the removal procedure.
back cover and/or pad, and trans-
fer the listing wires to the new cover
(Figs. 5 and 6).
5. To install the cover or pad,
reverse the removal procedure.
R1256-A