Table of Contents
Advertisement
(019)
bolt nut and wave washer. The wave
washer is positioned on the shoulder
bolt between the vacuum piston link
and the release lever. The link and
release lever must pivot freely.
3. Install the parking brake con-
trol assembly in the car as described
under "Installation" in the fore-
going procedure.
4. Test the lock and automatic
release operations of the parking
brake control assembly with the
engine running in all the transmission
selector lever positions. With the
engine running, the parking brake
should remain engaged in neutral or
park and should release in any drive
position.
BRAKE PEDAL
REMOVAL
1. Disconnect the battery ground
cable.
PART 2-2-BRAKE SYSTEM
2. From inside the car, remove
the six retaining screws and the in-
strument panel lower outer extension
from the underside of the instrument
panel.
Before removing the lower outer
extension from cars equipped with a
speed control, remove the control
head (two retaining screws) from
the
underside of the
instrument
panel. Disconnect the light and wire
(plug-in connector) from the con-
trol lead.
3. Remove the C-washer that re-
tains the push rod to the brake pedal
assembly (Fig. 16), and disconnect
the rod from the pedal. Remove the
bushings from the rod.
4. Remove the nut from the brake
pedal pivot bolt.
5. On cars equipped with air con-
ditioning, remove the air condition-
ing icing switch, motor and bracket.
ARMOR EXTENDS FORWARD OF CLAMP
l
5fs
II
lf4 ,
ON RIGHT SIDE
2
Ya
11
:j~
1
/4 "
ON LEFT
~
/
EQUAliZER-TO-REAR
-----
'EQUALIZER-TO-CONTROL CABLE
STOP
FIG. 17
-Parking Brake System
2-15
Remove the pivot bolt and the brake
pedal assembly from the support
bracket.
INSTALLATION
1.
Position the brake pedal assem-
bly in the support bracket and install
the pivot bolt and nut. Install the
air conditioning icing switch, motor
and bracket assembly on cars so
equipped.
2. Install the nylon bushings in the
eye of the push rod. Lubricate the
bushings. Connect the push rod to
the brake pedal assembly and secure
with the C-washer (Fig. 16).
3. Position
the
hood
release
handle and cable assembly in the
bracket at the bottom of the instru-
ment panel, and tighten the lock nut.
4. Position the lower outer ex-
tension assembly to the underside of
HORSE SHOE CLIP
H1288-A
Advertisement
Table of Contents
Troubleshooting
