Front Door Lock; Windshield Prepared For Installation; Bonded Windshield Rear View Mirror Installation - Lincoln Continental 1964 Shop Manual

(355)
PART 17-3- DOORS, WINDOWS AND DECK LID
17-31
CORD
Va"
SASH CORD
R1235-A
FIG.
14-Windshield Prepared for Installation
5. Apply the mixed resin to the
bracket mounting surface. Level off
the resin film as smoothly as possible.
6. Place the mounting bracket sur-
face upward in a vise or in a small
mound of permagum or any suitable
holding material that will support the
mounting bracket as shown in Fig.
15. Hold a standard 250-watt infra-
red lamp about five to six inches from
the mounting surface of the bracket
for two and one-half minutes (Fig.
15).
7. Allow the bracket to cool for
one minute. With light hand pres-
sure, apply the mounting surface of
the bracket to the desired inside area
of the windshield.
(
8. Secure the bracket to the wind-
shield using a piece of tape about
five inches long located just under
the knob of the bracket (Fig. 15) .
Apply another piece of tape in the
vertical direction to firmly hold the
mounting bracket in place on the
windshield.
9. When the temperatures are
above 67° F., the mirror and arm
should not be mounted for eight
hours, to allow the resin to properly
adhere the bracket to the glass. How-
ever, the car may be used with the
bracket taped in place one hour after
installation.
10. After the bracket has had time
to adhere to the glass, remove the
tape and install the mirror and arm
to the bracket.
EPOXY
CATALYST
FRONT DOOR LOCK
REMOVAL
1. Remove the door trim panel
and water shield.
2. Remove the window rear run
access covers from the door outer
edge.
3. Remove the rear run retaining
screws and remove the rear run from
the door.
4. Disconnect the door lock re-
mote control rod (remote control
link) from the door lock assembly.
5. Disconnect the outside door
handle button-to-lock rod (door lock
actuating rod) from the lock assem-
bly (Fig. 16).
6. Remove the door lock vacuum
control retaining screws and discon-
nect the vacuum control rod from
the lock assembly.
7. Disconnect the lock cylinder-
to-lock assembly rod from the lock
assembly.
8. Remove the lock assembly re-
SECTIONAL VIEW AA
MIRROR ASSEMBLY
R1174-B
When the temperatures are below
67° F., the mirror and arm should
not be mounted to the bracket for
16 hours, but the car can be used
two hours after the bracket has been
taped in place.
FIG.
15-Bonded Windshield Rear View Mirror Installation