Luggage Compartment; Lock Cylinder; Luggage Compartment Lock Mechanism - Lincoln Continental 1964 Shop Manual

(359}
PART 17-3-DOORS, WINDOWS AND DECK LID 17-35
SLEEVE AND
CYLINDER ASSEMBLY
LOCK STRIKER
~SHIELD
~
N1212-B
FIG.
18-Luggage Compartment Lock Mechanism
two bottom sash cords out to the
corners of the glass and then pulling
out the two top cords the remaining
way around the glass while a helper
applies pressure from the outside.
8. Remove the strips of tape that
temporarily held the weatherstrip in
place.
9. Install the inside garnish mould-
ings.
10. Install the outside and lower
mouldings.
11. Clean the glass and mouldings
and test for water leaks.
LUGGAGE COMPARTMENT
LOCK CYLINDER
1. Open the luggage compartment
door.
2. Remove two screws and remove
the door lock access cover plate (Fig.
18).
3. Disconnect the latch rod from
the lock cylinder shaft.
4. Remove the lock cylinder re-
taining nut and spacer from the lock
cylinder housing.
5. Pull the lock cylinder and pad
from the door.
6. Insert the key in the lock cyl-
inder. Depress the plunger retaining
the lock cylinder in the housing and
remove the lock cylinder.
7. To install, reverse the removal
procedure and check the operation
of the lock . .
DOOR-MODEL 53
1. Lay a protective covering over
the upper back panel and quarter
panels.
2. Disconnect the lamp wiring.
3. Remove the four cap screws
which secure the hinges to the door
and remove the door.
4. To install, position the door on
the hinges. Install the four cap screws
just tight enough to permit the door
to be shifted, if necessary, for proper
alignment; then, tighten the cap
screws. Connect the lamp wire.
HINGES-MODEL 53
1. Prop the luggage compartment
door open.
2. Loosen the torsion rod tension
bolts until all tension is relieved from
the torsion rods (Fig. 19).
3. Remove the torsion rods from
the hinge.
4. Remove three cap screws and
remove the hinge from the car. For
the left hand hinge removal, the
left quarter wheelhouse trim cover
assembly has to be removed.
5. To install, reverse the removal
procedure.
HINGE ASSEMBLY
FIG.
19-Luggage
Compartment Door Hinge
Torsion Rods
N1380~A