Camshaft Bearing Replacement; Thrust Bearing Alignment; Crankshaft End Play; Camshoft Bearing Removal And Installation - Lincoln Continental 1964 Shop Manual

8-48
PRY CRANKSHAFT FORWARD
FIG.
64-Thrust Bearing Alignment
der "Timing Chain, Camshaft and
Crankshaft Sprockets Installation."
27. Install the oil slinger on the
crankshaft, with the concave side of
the slinger facing the rear of the
engine.
28.
Install the cylinder front cover,
power steering pump and reservoir,
and crankshaft damper following
steps 1 thru 4 under "Cylinder Front
Cover Installation."
29. Coat new water pump gaskets
with water-resistant sealer. Install the
gaskets, water pump, oil level dip-
stick tube bracket, and power steer-
ing reservoir mounting bracket.
Torque the water pump mounting
bolts to specifications. Torque the
power steering pump reservoir
bracket mounting bolts to specifica-
tions. Tighten the bypass hose clamp.
30. Install the fuel pump push rod
in the cylinder front cover. Install a
new cup-type plug in the top of the
cover.
31. Coat a new fuel pump gasket
with an oil-resistant sealer. Install the
gasket and fuel pump on the cylinder
front cover and torque the mounting
bolts to specifications. Connect the
fuel vapor line to the fuel pump. In-
FIG.
65-Crankshaft
End
Pia~
GROUP
I-ENGINE
PRY BACKWARD
PRY CAP BACKWARD
stall the fuel pump shield.
32.
Connect the fuel inlet line at
the carburetor. Install the generator
and bracket. Install the spark plugs.
33. Install the engine in the car.
CAMSHAFT BEARING
REPLACEMENT
Camshaft bearings are prefinished
to size for standard and undersize
camshaft bearing journals. The bear-
ings are not interchangeable from
one cylinder block bore to another.
They must be installed in the bore
designated by the number stamped
on the outside diameter of each bear-
(168)
TIGHTEN CAP
A1888-A
ing. The camshaft bearing inside di-
ameters decrease in size from the
front of the engine toward the rear
(refer to Part
8-3).
1. Remove the camshaft, the fly-
wheel and the crankshaft. Push the
pistons to the top of the cylinders.
2.
Remove the camshaft bearing
bore plug from the rear of the cylin-
der block, with the shaft of tool
6261-F or a long rod.
3. Remove the camshaft bearings
(Fig. 66).
4.
Clean the camshaft rear bear-
ing bore plug recess thoroughly.
Clean and inspect the camshaft bear-
Clamp
Adapter Set,
Tooi-6261-AC
/Clamp
;' ! .J
A1890-A
FIG.
66-Camshoft Bearing Removal and Installation