Secondary Throttle Lockout Adjustment; Throttle Linkage Adjustments - On The Car; Fuel Filter Replacement; Anti-Stall Dashpot Adiustment - Lincoln Continental 1964 Shop Manual

10-8
At this point, the secondary throttle
plate should just start to open. To
adjust, bend the throttle operating
rod at the existing bend (Fig. 13).
3. When both the primary and
secondary throttle plates are com-
pletely closed, there should be the
specified clearance (tool 9597-B)
between the positive closing shoes on
the primary and secondary throttle
levers (Fig. 14). To adjust, bend the
shoe on the secondary throttle lever
(Fig. 14).
SECONDARY THROTTLE
LOCKOUT ADJUSTMENT
1. Open the throttle plates slightly,
then manually open and close the
choke plate. As the fast idle cam
moves the lockout plate, the tang on
the secondary throttle lever should
freely engage in the notch (Fig. 15).
2. To adjust the secondary throttle
lever, bend the lever tang as required
(Fig. 15).
3. Hold the lockout plate to the
left and tight against the stop on
the main body casting (secondary
throttle plates partially open). The
clearance (Fig. 16) between the tang
on the secondary throttle lever and
the ramp on the lockout plate should
be within specification.
4. To adjust the clearance, bend
the arm at the slot on the lockout
plate, as required (Fig. 16).
IDLE FUEL MIXTURE AND
IDLE SPEED ADJUSTMENTS-
ON THE CAR
The idle fuel mixture and idle
speed adjustments are performed
with the carburetor installed on the
engine. Refer to Part 2, Section 2
for the proper procedure.
THROTTLE LINKAGE
ADJUSTMENTS - ON THE CAR
The throttle linkage adjustments
for the Turb-O-Drive transmission
are covered in Group 7.
FUEL FILTER REPLACEMENT
A replaceable fuel filter is located
between the fuel pump and the car-
buretor fuel inlet line (Fig. 17). Re-
place the eletnent if it becomes
clogged, and also at the recommend·
ed main.tenance mileage interval.
GROUP 10-FUEL SYSTEM
(212)
AT CLOSED THROTTLE, THIS DIMENSION SHOULD BE
Ya
INCH.
TO ADJUST, BEND LEVER TANG WITH Tooi-9564-A
AIR HORN
FIG.
12-Anti-Stall Dashpot Adiustment
AT WIDE OPEN THROTTLE THIS
DIMENSION SHOULD BE
¥!6
INCH.
81947-A
BEND HERE TO ADJUST-
USE
Tool-99798
81948-A
FIG.
13-Secondary Throttle Plate Adiustment