Remote Control; Rear Door Hinges-Upper And Lower; Back Window And/Or Weatherstrip - Lincoln Continental 1964 Shop Manual

17-34 GROUP 17-BODY, DOORS AND WINDOWS
(358)
5. Hold the regulator in a vise and
remove the motor assembly.
6. Preload the replacement regula-
tor to the correct position. Hold the
regulator in a vise and install the
motor assembly on the regulator.
7. To install, reverse the removal
procedure.
REMOTE CONTROL
1. Remove the door trim panel and
water shield.
2. Remove three remote control
mounting screws, disconnect the re-
mote control rod and remove the
remote control from the door.
3. To install, reverse the removal
procedure.
REAR DOOR HINGES-
UPPER AND LOWER
1. Remove the trim panel and
water shield.
2. Remove the courtesy light switch
and bracket.
3. Remove three cap screws secur-
ing the lower hinge to the door.
4. Remove three cap screws secur-
ing the top hinge to the door.
5. Position the door off the hinge
and place it on a low bench or box
by the car. It is not necessary to
remove the wire harness from
the door for hinge replacement.
6. To remove the lower hinge, re-
move two cap screws and one nut
securing the lower hinge to the body
and remove the hinge.
7. To remove the top hinge, re-
move the two cap screws securing
the top hinge to the body and remove
the hinge.
8. To install, reverse the removal
procedure.
BACK WINDOW AND/OR
WEATHERSTRIP
REMOVAL
1. Remove the two back window
outside mouldings and the two out-
side lower mouldings (Fig. 17).
2. Remove the back window left
side garnish moulding.
3. Remove the back window right
side garnish moulding.
4. Remove the back window lower
garnish moulding.
5. Free up the inside lip of the
weatherstrip.
6. With a helper, remove the win-
dow and weatherstrip as an assembly.
7. Remove the weatherstrip from
the glass.
8. Clean the weatherstrip thor-
oughly and inspect it for cracks or
FIG.
17-Back Window and Exterior Mouldings
tears. Replace the weatherstrip if
necessary.
9. Remove all old sealer from the
window opening pinchweld flanges.
INSTALLATION
1. Apply an even bead of sealer in
the weatherstrip window opening
groove.
2. Position the weatherstrip on the
glass. Place masking tape at intervals
to retain the weatherstrip to the
glass.
3. Clean off any excess sealer from
the inside of the glass and weather-
strip.
4. Place two lengths of Ys -inch
sash cord in the body flange. groove
of the weatherstrip so that the cord
ends overlap each other approxi-
mately 12 inches at the upper and
lower center of the glass. Tape the
cord ends temporarily to the inside
of the glass.
5. Apply an even bead of sealer
all the way around the edge of the
body opening pinchweld flange (Fig.
17). Position the moulding retainers
as shown in Fig. 17.
6. With a helper, place the window
assembly in the window opening.
7. Pull the inner lip of the weath-
erstrip over the pinchweld flange.
This is accomplished by pulling the
R1257-A