Function Tests - Genie GS-2668 RT Operator's Manual

First Edition · Tenth Printing
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to
use.
Know and understand the function tests
before going on to the next section.
4 Inspect the work place.
5 Only use the machine as it was intended.
Fundamentals
The Function Tests are designed to discover any
malfunctions before the machine is put into
service. The operator must follow the step-by-step
instructions to test all machine functions.
A malfunctioning machine must never be used. If
malfunctions are discovered, the machine must be
tagged and removed from service. Repairs to the
machine may only be made by a qualified service
technician, according to the manufacturer's
specifications.
After repairs are completed, the operator must
perform a pre-operation inspection and function
tests again before putting the machine into service.
Part No. 48735
1 Select a test area that is firm, level and free of
At the Ground Controls
2 Pull out the platform and ground red Emergency
3 Turn the key switch to ground control.
4 Observe the diagnostic
5 Start the engine. See
Test Emergency Stop
6 Push in the ground red Emergency Stop button
7 Pull out the red Emergency Stop button to
Test the Up/Down Functions
The audible warnings on this machine and the
standard horn all come from the same central
alarm. The horn is a constant tone. The descent
alarm sounds at 60 beeps per minute. The alarm
that goes off when the machine is not level sounds
at 180 beeps per minute.
8 Do not hold the function enable switch to either
Genie GS-2668 RT & Genie GS-3268 RT

Function Tests

obstruction.
Stop button to the position.
ON
LED readout.
Result: LED should look
like picture at right.
Operating Instructions
section.
to the position.
OFF
Result: The engine should turn off and no
functions should operate.
the position and restart the engine.
ON
side and activate the platform up function.
Result: No function should operate.
Operator's Manual
17