Genie GS-2668 RT Operator's Manual page 20

Operator's Manual
FUNCTION TESTS
9 Hold the function enable switch to either side
and activate the platform up function.
Result: The platform should raise.
10 Hold the function enable switch to either side
and activate the platform down function.
Result: The platform should lower. The descent
alarm should sound while the platform is
lowering.
Test the Manual Lowering
11 Hold the function enable switch to either side
and activate the platform up function and raise
the platform approximately 2 feet (0.6 m).
12 Pull the manual lowering knob or push the
manual lowering button located next to the
ground controls.
Result: The platform should lower. The descent
alarm will not sound.
13 Turn the keyswitch to platform control.
At the Platform Controls
Test Emergency Stop
14 Push in the platform red Emergency Stop button
to the position.
OFF
Result: No functions should operate.
15 Pull the red Emergency Stop button out to the
position.
ON
Result: The green power light should come on.
18
Test the Horn
16 Push the horn button.
Test the Up/Down Functions and the Function
Enable Switches
17 Start the engine.
18 Activate the platform up function.
19 Push and hold a function enable/speed select
20 Activate the platform up function.
21 Release the function enable button.
22 Push and hold a function enable/speed select
Test the Steering
Note: When performing the steer and drive function
tests, stand in the platform facing the steer end of
the machine.
23 Press and hold the function enable switch.
24 Depress the thumb rocker switch on top of the
Genie GS-2668 RT & Genie GS-3268 RT
First Edition · Tenth Printing
Result: The horn should sound.
Result: The platform should not raise.
button.
Result: The platform should raise.
Result: The platform should stop raising.
button. Activate the platform down function.
Result: The platform should lower. The descent
alarm should sound while the platform is
lowering.
control handle in the direction identified by the
blue triangle on the control panel.
Result: The steer wheels should turn in the
direction that the blue triangle points on the
control panel.
Part No. 48735