Genie GS-2668 RT Operator's Manual page 26

Operator's Manual
OPERATING INSTRUCTIONS
Manual Control Outriggers
(if equipped)
An outrigger option is available for Genie
GS-2668RT and GS-3268RT models that can be
installed in the field. The outriggers are operated
from a control box mounted outside of the platform.
These instructions apply to this additional control
box.
1 Position machine below the desired work area.
2 Pull out the red Emergency Stop buttons at the
ground and platform controls. Also pull out the
red Emergency Stop button on the outrigger
control panel.
3 Activate the outrigger raise/lower toggle
switches and adjust to level the machine and
raise the wheels slightly off the ground. Use the
bubble level located on the control box mount.
Each toggle switch operates two outriggers.
4 Raise the platform. If the tilt alarm sounds, fully
lower the platform and adjust the outriggers.
Use the bubble level located on the control box
mount.
The red indicator light above the lift symbol on the
outrigger control panel comes on when one but not
all outriggers are down. All drive and lift functions
are disabled.
The light turns off when all outriggers are in firm
contact with the ground. The drive function is
disabled while the outriggers are down.
If you try to operate a function that is locked out,
the fault light on the platform control panel will
come on and the machine will be disabled. This will
happen even if the outriggers are in firm contact
with the ground and the red indicator light on the
outrigger control box is off.
To operate the machine, push in the red
Emergency Stop button and then pull it out to
position. Restart the machine.
24
Auto Level Outriggers
(if equipped)
These instructions apply to machines with the
black auto level outrigger control box.
1 Position machine below the desired work area.
2 Pull out the red Emergency Stop buttons at the
3 Push and hold the auto level button.
4 Activate the outrigger up/down toggle
The red indicator light above the lift symbol on the
outrigger control panel comes on when one but not
all outriggers are down. All drive and lift functions
are disabled.
The light turns off when all outriggers are in firm
contact with the ground. The drive function is
disabled while the outriggers are down.
To control individual outriggers
1 Push and hold the outrigger function
2 Push and hold an outrigger
3 Activate the outrigger up/down
Positioning machine on a slope
When setting the machine up on a slope, the
steer-end outriggers must be lowered first.
ON
Genie GS-2668 RT & Genie GS-3268 RT
First Edition · Tenth Printing
ground and platform controls.
switch in the down direction.
Result: The outriggers will extend and level the
machine. A beep will sound when the machine
is level.
enable button.
button.
toggle switch in the desired
direction to level the machine.
Part No. 48735