Genie GS-2668 RT Operator's Manual page 21

First Edition · Tenth Printing
25 Depress the thumb rocker switch in the direction
identified by the yellow triangle on control panel.
Result: The steer wheels should turn in the
direction that the yellow triangle points on the
control panel.
Test Drive and Braking
26 Press and hold the function enable switch.
27 Slowly move the control handle in direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
28 Press and hold the function enable switch.
29 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The drive brakes must be able to hold the
machine on any slope it is able to climb.
Test Limited Drive Speed
30 Move and hold a function enable/speed select
switch. Raise the platform approximately 6 feet
(1.83 m) from the ground.
31 Press and hold the function enable switch.
32 Slowly move the control handle to the full drive
position.
Result: The maximum achievable drive speed
with the platform raised should not exceed 0.73
feet per second (0.22 meters per second).
Part No. 48735
If the drive speed with the platform raised exceeds
0.73 feet per second (0.22 meters per second),
immediately tag and remove the machine from
service.
Test Platform Extension Limit Switch (if
equipped)
Note: Some GS-2668 machines do not have a
platform extension limit switch. Check under the
extension end of the platform to locate this switch.
This test is not necessary on machines that are not
equipped with this limit switch.
33 Move and hold a function enable/speed select
34 Extend the platform extension.
35 Press and hold the function enable switch.
36 Slowly move the control handle to the full drive
Lower the platform or retract the platform
extension to drive.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
37 Fully lower the platform.
38 Drive both wheels on one side onto a 4 inch
39 Raise the platform.
40 Lower the platform and drive the machine off
Genie GS-2668 RT & Genie GS-3268 RT
switch. Raise the platform to full height.
position.
Result: The drive function should not operate.
(10 cm) block or onto a curb.
Result - ANSI and CSA models: The tilt alarm
will sound at 180 beeps per minute.
Result - CE models: The drive function and the
lift function will not operate and the tilt alarm
will sound at 180 beeps per minute.
the block.
Operator's Manual
FUNCTION TESTS
19