Genie GS-2668 RT Operator's Manual page 7

First Edition · Tenth Printing
Collision Hazards
Be aware of extended platform position when
moving the machine.
Machine must be on level surface or secured
before releasing brakes.
It is recommended that operators wear an approved
hard hat when operating the machine.
Check work area for overhead obstructions or other
possible hazards.
Be aware of crushing hazard when grasping the
platform guard rail.
Observe and use color-coded direction arrows on
the platform controls and platform decal plate for
drive and steer functions.
Do not operate a machine in the path of any crane
or moving overhead machinery unless the controls
of the crane have been locked out and/or
precautions have been taken to prevent any
potential collision.
No stunt driving or horseplay while operating a
machine.
Part No. 48735
Be aware of limited sight
distance and blind spots
when driving or operating.
Genie GS-2668 RT & Genie GS-3268 RT
Do not lower the platform unless the area below is
clear of personnel and obstructions.
Limit travel speed according to condition of ground
surface, congestion, slope, location of personnel
and any other factors which may cause collision.
Component Damage Hazards
Do not use any battery or charger greater than 12V
to jump-start the engine.
Do not use the machine as a ground for welding.
Be sure hydraulic shutoff valves (located by
hydraulic tank) are open before starting engine.
Explosion and Fire Hazards
Do not start the engine if you smell or detect liquid
petroleum gas (LPG), gasoline, diesel fuel or other
explosive substances.
Do not refuel the machine with the engine running.
Refuel the machine and charge the battery only in
an open, well-ventilated area away from sparks,
flames and lighted tobacco.
Do not operate the machine in hazardous locations
or locations where potentially flammable or
explosive gases or particles may be present.
Operator's Manual
SAFETY RULES
5