10 Settings
Tab.45
Temps / mode CH1 – Temps / mode CH2 – Temps / mode CH3 menu
Parameter number
Heating
Heating
Heating cir
circuit 1
circuit 2
cuit 3
700
1000
1300
710
1010
1310
712
1012
1310
Tab.46
Structure of the installer menu
Menu
Installer
Tab.47
Operator section menu
Parameter
Parameter
number
24
Lighting
29
Units
80
POWER HT +
Parameter
Description
The control unit is installed on the boiler:
Off : heating is deactivated.
Timed : the heating is dependent on the timer pro
gram.
Reduced : heating is in permanent reduced mode.
On : heating is in permanent reduced mode.
The control unit is installed as a room temperature
Operating
control system:
mode
Off : the boiler starts up when the room tempera
ture falls below the frost protection set point.
Timed : the heating is dependent on the timer pro
gram.
Reduced : the room temperature set point is the
reduced set point (Parameters 712, 1010, 1310)
On : the room temperature set point is the comfort
set point (Parameters 710, 1010, 1310)
Comfort
setpoint
Reduced
temp setpoint
10.1.4
List of installer parameters
Sub-menu
Operator section
Temps / mode CH1
Temps / mode CH2
Temps / mode CH3
Temps / mode hot water
Boiler Settings
Solar
Configuration
Error
Service/special operation
State
Diagnostics heat generation
Burner control
Description
Off
Temporarily
Permanently
°C, bar
°F, PSI
Factory setting
On
20 °C
16 °C
Factory set
ting
Temporarily
°C, bar
7702630 - v02 - 11082018