Automatic Error Code Clearing; Clearing Error Codes - Baxi POWER HT+ Series Installation, User And Service Manual

12 Troubleshooting
Fig.200
----------------------------------------------------
Information Information
Set time and date
6"
12.3

Automatic error code clearing

12.4

Clearing error codes

130 POWER HT +
2. Press the
3. Select the Commissioning menu by turning the
4. Confirm the menu selection by pressing the
MENU
MENU
5. Select the Error menu by turning the
6. Confirm the menu selection by pressing the
MW-3000082-EN-03
If the symbol
code is automatically cleared when the cause that prompted it stops.
A flow or return temperature in excess of the critical value prompts an
error code. The error code is automatically cleared when the temperature
drops below the critical value.
If the probable cause of an error code is resolved but the error code
continues to be displayed, proceed as follows to clear the error code:
1. Press the
2. Confirm by pressing the
and keys simultaneously for at least 6 seconds.
MENU
Important
Press the key to return to the main display.
MENU
The list of parameters for the Error mode can now be accessed.
Use the button to consult them.
Important
Press the key to return to the main display.
MENU
For more information, see
List of installer parameters, page 80
is displayed at the same time as the error code, the error
button.
The command Reset? Yes is displayed on the control panel.
button.
The error code disappears after a few seconds.
button.
button.
button.
button.
7702630 - v02 - 11082018