®
Invacare
- Dragon Vertic
8.5
Adjusting the armrests and the control panel
8.5.1
Adapting the height of the armrests
Pre-requisites:
· 5 mm Allen key
·
Loosen the eight Allen screws (1) (only
the four on the right side are to be seen
in the picture).
·
Adjust the height of the armrests.
·
Re-tighten the screws.
8.5.2
Setting the angle of the swing-up armrest
Pre-requisites:
· 5 mm Allen key
· 13 mm open-ended spanner
WARNING: Damage to the wheelchair may result if the height of armrests is unevenly
adjusted!
· The armrests should only ever be adjusted parallel to each other, never higher on one side
and lower on the other!
·
Use the open-ended
spanner to loosen the
counternut (1).
·
Adjust the Allen screw (2)
until the desired setting
angle of the armrest has
been achieved.
·
Re-tighten the counternut
(1).
SERVICE MANUAL
61