7.16.2 Replacing The Additional Belt - Invacare Dragon Vertic Service Manual

SERVICE MANUAL
Uninstalling the chest strap:
●
Loosen and remove the hexagon socket head screws (1) together with the washers.
●
Remove the mounting plate (2) of the additional belt (3).
●
Remove the chest strap (4). Pay attention to the insert (5) while doing this.
Installing the chest strap:
●
Place the insert into the chest strap.
●
Position the mounting plate of the additional belt.
●
Install the hexagon socket head screws with the washers. These have to go through the holes
provided in the components, and are screwed into the sliding block (6).
●
Set the height of the chest strap approximately to the desired height and tighten the Allen
screws.
●
Set the exact height of the chest strap later together with the user, see Chapter 8.6.

7.16.2 Replacing the additional belt

Requirements:
· 13 mm socket wrench
Uninstalling the additional belt:
●
Loosen and remove the box nut (5) together with the washer (4).
●
Remove the attachment bracket (3) of the additional belt.
Note
It is not necessary to remove the nut (2) and the washers (1). These are mounted as spacers so
that the belt attachment bracket can rotate freely.
Installing the additional belt:
●
Assemble the parts in reverse order.
50
®
Invacare - Dragon Vertic