Repairing A Flat Tyre (Pneumatic Tyre Equipment Type 220/120 X 50) - Invacare Dragon Vertic Service Manual

®
Invacare - Dragon Vertic
·
Re-insert the rim halves into the tyre from the outside.
·
Inflate the inner tube slightly with air.
·
Re-apply the cylinder head bolts and screw rim together tightly.
·
Check the exact fit of the shoe.
·
Inflate the tyre to the prescribed air pressure.
·
Re-check the exact fit of the shoe.
·
Screw on the valve cap.
·
Re-install the wheel.

7.11.2 Repairing a flat tyre (pneumatic tyre equipment type 220/120 x 50)

Pre-requisites:
· 6 mm Allen key
· 13 mm open-ended spanner
· 2 x small ring spanners or flat screwdrivers (for removing the shoe)
· Repair kit for inner tube tyres or a new inner tube
· Talcum powder
Removing the wheel
·
Jack up the vehicle (place a wooden wedge under
the frame).
·
Loosen and remove the screw (1) using the Allen
key on one side and the open-ended spanner on the
other side (for countering).
·
Pull the wheel from the fork
PLEASE NOTE
Installation is carried out in reverse order. Please ensure that the wheel is re-fitted on the same
side and in the same running direction as removed.
Repairing a flat tyre
·
Unscrew the valve cap.
·
Exhaust the air from the tyre by pressing the spring
pin in the valve.
·
Use the flat screwdrivers or other tools to carefully
remove the shoe from the rim. Do not damage the
tube if this is to be used again.
·
Repair the tube and re-fit or fit new tube.
SERVICE MANUAL
43