Replacing The Acs Remote - Invacare Dragon Vertic Service Manual

SERVICE MANUAL
7.9

Replacing the ACS Remote

Pre-requisites:
· Phillips screwdriver
· To modify a drive programme you will need: Programming software or a Handheld
Programmer and the Installation Manual of the ACS Electronics, available from Invacare®.
NOTE
All ACS remotes are supplied with a standard drive programme. If the driving programme has
been customised, then you will have to perform this customisation again, after installing the new
electronic module.
WARNING: Every alteration to the drive programme can influence vehicle handling and
the tipping stability of the wheelchair!
· Alterations to the drive programme must only be carried out by trained Invacare®-dealers!
· Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for unaltered standard drive programmes!
·
Switch off the remote.
·
Pull the bus cable (1) out of the remote.
·
Loosen the thumb screw (2).
·
Pull the remote and the remote holder out of
the guiding device.
·
Unscrew both remote holder screws (1)
using the crosstip screwdriver.
38
®
Invacare - Dragon Vertic