Replacing The Shark Electronics - Invacare Dragon Vertic Service Manual

SERVICE MANUAL
7.3

Replacing the Shark Electronics

Pre-requisites:
· Phillips screwdriver
· To modify a drive programme you will need: Programming software or a Handheld
Programmer and the Installation Manual of the Shark Electronics (Part Number 1436160),
available from Invacare®.
NOTE
All electronic modules are supplied with a standard drive programme. If the driving programme
has been customised, then you will have to perform this customisation again, after installing the
new electronic module.
WARNING: Every alteration to the drive programme can influence vehicle handling and
the tipping stability of the wheelchair!
· Alterations to the drive programme must only be carried out by trained Invacare®-dealers!
· Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for unaltered standard drive programmes!
·
Unscrew the handwheels (screws) (1) on
both sides of the panelling for the
electronics.
·
Remove the electronic panelling.
·
Disengage all the plugs (1) on the electronic
module.
28
®
Invacare - Dragon Vertic