SERVICE MANUAL
7.15
Replacing the safety belt
Requirements:
· 10 mm socket spanner
· 4 mm Allen key
Dismantling the safety belt:
·
Remove the plastic cap (5).
·
Loosen the bolt (3) and the associated nut (in the figure this is covered) with a 4 mm Allen key
and a 10 mm socket spanner.
·
Remove the nut incl. the washer.
·
Remove the screw incl. the safety belt, the washer (2) and the washer arranged behind.
Note
Another nut is fixed between the two washers (2) and (4) as a spacer so that the belt mounting
can rotate freely.
·
Replace the safety belt (1).
Refitting the safety belt:
·
Refit the parts in reverse order.
48
®
Invacare
- Dragon Vertic