FX-10DM-E DISPLAY MODULE
1.5
Preparation and startup
This paragraph describes the procedure from installation and wiring of the 10DM to menu dis-
play in the 10DM.
Learn the panel face processing and 10DM mounting procedures.
Title screen
COPYRIGHT(C)2000
MELSEC FX-10DM-E
time of startup after
First time after
shipment
To "SYSTEM MODE"
Confirm accessories of the 10DM.
Learn the name of each part.
Connect 10DM and FX Series PLC with cable.
If "[FNC] + [ENT]" are pressed
Turn on the power of the 10DM.
Turn on the power of the PLC.
MITSUBISHI
V1.00
Is it the first
Second time or later
shipment?
To Section 4
The mode stored when power was turned off last time is displayed.
To Section 4
To "SYSTEM MODE"
Introduction 1
Refer to Paragraph 1.6.
Refer to Paragraph 1.7.
Refer to Paragraph 3.1.
Refer to Paragraph 3.2.
1-7
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list