Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
2) Connecting the cable to the PLC
In the case of FX-20P-CAB
Hold the other D-sub, 25-pin connector of the cable FX-20P-CAB0/EN by hand. Let the con-
nector be in the lateral direction and its longer edge be located on the upper side, securely
insert it completely.
In the case of FX-20P-CAB0 and FX-20P-CAB0/EN
Hold the other mini-DIN, 8-pin connector of the cable FX-20P-CAB0/EN by hand. Align the
"L" mark with the direction of the notch on the programming connector of the PLC, and
securely insert the connector completely.
3) Fix the cable securely so that it will not come off the 10DM.
Installation, Wiring and Maintenance 3
3-5
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list
Advertisement
Table of Contents
