Table of Contents
Advertisement
FX-10DM-E DISPLAY MODULE
1.7
Name of each part
The name and function of each part of the 10DM are described below.
1) Front panel
a) Display unit
Displays alphabets, numeric and Katakana charac-
ters and symbols in 16 half-width characters by 2
lines.
b) [CLR] key
Clears a device No. or numeric value being input, and
returns to the initial status.
c) [FNC] key
Sets the line selection mode when pressed and held for 1 second or more.
While a numeric value is being input, this key specifies the digit.
d) [L] and [M] keys
Decrease or increase a device No. or numeric value, and scroll the display line.
e) [ENT] key
Completes input of a device No., numeric value or menu item selection.
2) Rear panel
a) Connector for PLC (RS-422 interface)
Enables communication between the 10DM and the
FX Series PLC.
The power is supplied from the PLC via a cable con-
nected to this connector.
Introduction 1
a)
CLR
FNC
b)
c)
d)
a)
1-9
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
ENT
Menu
5.Environ-
e)
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list
Advertisement
Table of Contents
