Example Of Manual Bandwidth Control; Networking Requirement; Configuration Procedure - Tenda W15E User Manual

Status
Operation
Bandwidth of
Unlimited Hosts
QoS for Guest
Network
8.4

Example of Manual Bandwidth Control

8.4.1

Networking requirement

A company uses W15E to deploy a network. The LAN IP of the router is 192.168.0.1, and the subnet mask is
255.255.255.0.The bandwidth control function is used to enable every client connected to the router to share a
fixed bandwidth. Assume that the IP range is 192.168.0.2~192.168.0.250, and the time period to control the
bandwidth is 8:00~18:00.
8.4.2

Configuration procedure

Step 1 Set the Time Group (8:00 ~ 18:00). See 7.1.2 Adding the Time Group for detailed configuration steps.
Step 2 Set the IP Group (IP range: 192.168.0.2 ~ 192.168.0.250). See 7.1.3 Adding the IP Group for detailed
configuration steps.
It specifies the current status of the rule, including Enabled and Disabled.
The following operations can be preformed on the rules:
: It is used to disable the rule.

 : It is used to enable the rule.
It is used to edit the rule.

: It is used to delete the rule.

When selected, bandwidth of devices covered by the disabled rules and the bandwidth

of devices not covered by any enabled rule are subject to the default parameters.
When unselected, only devices not covered by enabled rules takes effect.

It specifies the maximum upload/download rate of each client connected to the guest
network.
86