BRAKES
Adjusting basic position of foot brake lever
11.11
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to over-
heating. Adjust free travel on foot brake lever according to specifications.
x
–
Disconnect spring
–
Loosen nut
–
To adjust the basic position of the foot brake lever individually, loosen nut
screw
accordingly.
Info
The range of adjustment is limited.
–
Turn push rod
position of the foot brake lever.
Guideline
Free travel at foot brake lever
–
Hold screw
Guideline
Remaining nuts, chassis
–
Hold push rod
Guideline
302829-10
Remaining nuts, chassis
.
and turn it back with push rod
accordingly until you have free travel
and tighten nut
.
and tighten nut
.
until you have maximum free travel.
. If necessary, adjust the basic
3... 5 mm (0.12... 0.2 in)
M8
30 Nm
(22.1 lbf ft)
M6
15 Nm
(11.1 lbf ft)
137
and turn