TUNING THE CHASSIS
–
Measure the overall spring length in an unloaded state.
Info
The spring preload
unloaded and when it is installed.
–
Tighten the spring by turning the adjusting ring to specified measurement.
Guideline
(Option: KT 771...)
Spring preload
Standard
(Option: KT 871...)
Spring preload
Standard
–
Tighten the lock nut and the adjusting ring.
Info
The adjusting ring
ring too tightly to avoid damaging the thread.
400363-11
If you increase the spring preload, you should also slightly increase the rebound
damping.
–
Install the rear shock absorber.
is the difference in length between the spring when it is
3 mm (0.12 in)
3 mm (0.12 in)
is made of plastic. Therefore, do not lock the adjusting
x
(
p. 90)
83