Appendix 3 - Wall Mounting; Preparing The Phone For Wall Mounting - VTech ErisTerminal ET605 User Manual

ET605 User Manual

Appendix 3 - Wall Mounting

The ET605 wall mount bracket is available as a separate accessory.
Front
The two holes on the wall bracket marked  can be hung on two screws or on the studs of a US standard
ethernet wall plate (4" center); bolting the bracket to the wall is optional and normally not necessary.
For the screw sizes and measurements for hole drilling, see "Measurements" on page 88.
Please note: Screws, expansion anchors, and standard ethernet wall plate are not included with
either phone or bracket.
Note: If the footstand is attached to phone, it must be detached before attaching the bracket.
P
reparing the phone for wall mounting
1. Plug the long end of the handset cord into the connector labeled "
place cord in the cable guide (Fig. 1) before attaching the wall bracket to the phone.
1
Fig. 1
2. Place the two hooks on the wall bracket (marked  in Fig. 2 and 3) into the holes marked  (Fig. 1 and 3)
on the bottom shell of the phone. Push the bracket upwards until the hooks click into place (Fig. 4).
Back
1
2
Cable guide
Fig. 2
" on the bottom shell of the phone and
2
1
Fig. 3
87
Appendix 3
2
Fig. 4