VTech ErisTerminal ET605 User Manual page 9

ET605 User Manual
D. If the product does not operate normally by following the operating instructions. Adjust only those
controls that are covered by the operation instructions. Improper adjustment of other controls may result in
damage and often requires extensive work by an authorized technician to restore the product to normal
operation.
E. If the product has been dropped and the telephone base and/or handset has been damaged.
F. If the product exhibits a distinct change in performance.
15. Avoid using a telephone (other than cordless) during an electrical storm. There is a remote risk of electric
shock from lightning.
16. Do not use the telephone to report a gas leak in the vicinity of the leak. Under certain circumstances, a
spark may be created when the adapter is plugged into the power outlet, or when the handset is replaced
in its cradle. This is a common event associated with the closing of any electrical circuit. The user should not
plug the phone into a power outlet if the phone is located in an environment containing concentrations of
flammable or flame-supporting gases, unless there is adequate ventilation. A spark in such an environment
could create a fire or explosion. Such environments might include: medical use of oxygen without adequate
ventilation; industrial gases (cleaning solvents; gasoline vapors; etc.); a leak of natural gas; etc.
17. Only put the handset of your telephone next to your ear when it is in normal talk mode.
18. The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs
are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
19. Use only the power adapter indicated in this manual.
Power adapter rating: 5 Vdc @ 2 A
20. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily
accessible.
21. In wall mounting position, make sure to mount the telephone base on the wall by aligning the eyelets with
the mounting studs of the wall plate. Then slide the telephone base down on both mounting studs until it
locks into place. Refer to the full instructions in Deskset Installation in the User Guide.
22. CAUTION: Keep small metallic objects such as pins and staples away from the handset receiver.
SAVE THESE INSTRUCTIONS
For UL compliance only
Safety, Disposal, Cleaning of Product
9