Draytek Vigor2133 User Manual page 682

wl_dual config ratectl show
wl_dual config isolate lan [ssid_num enable]
wl_dual config isolate member [ssid_num enable]
wl_dual config isolate vpn [ssid_num enable]
wl_dual config isolate show
S y n t a x
S y n t a x
Parameter
enable[value]
show
mode[value]
mode show
channel [number]
channel show
preamble [enable]
preamble show
ssid[ssid_num enable
ssid_name]
ssid hide [ssid_num enab le]
ssid show
ratectl [ssid_num enable
upload download]
ratectl show
670
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to enable/disable the 5GHz wireless function.
1: enable
0: disable
It means to display if 5G wireless function is enabled or not.
It means to select connection mode for wireless connection.
Available settings are: "11a", "11n_5g", "11n" and "11an".
It means to display what the current wireless mode is.
It means the channel of frequency of the wireless LAN.
The available settings are: 36, 40, 44, 48, 52, 56, 60, 64, 100, 104,
108, 112, 116, 120, 124, 128, 132, 136 and 140.
number=0, means Auto
number=36, means Channel 36
....
Number=52, means Channel 52.
It means to display what the current channel is.
It means to define the length of the sync field in an 802.11 packet.
Most modern wireless network uses short preamble with 56 bit sync
field instead of long preamble with 128 bit sync field. However,
some original 11b wireless network devices only support long
preamble.
0: disable to use long preamble.
1: enable to use long preamble.
It means to display if preamble is enabled or not.
It means to set the name of the SSID, hide the SSID if required.
ssid_num: Type 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3 or SSID4.
ssid_name: Give a name for the specified SSID.
It means to hide the name of the SSID if required.
ssid_num: Type 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3 or SSID4.
enable: Type 0 to hide the SSID or 1 to display the SSID.
It means to display a table of SSID configuration.
It means to set the rate control for the specified SSID.
ssid_num: Choose 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3 or SSID4.
enable: It means to enable the function of the rate control for the
specified SSID. 0: disable and 1:enable.
upload: It means to configure the rate control for data upload. The
unit is kbps.
download: It means to configure the rate control for data
download. The unit is kbps.
(example: wl dual config ratectl 1 1 25 25)
It means to display the data transmission rate (upload and
download) for SSID1, SSID2, SSID3 and SSID4.
Vigor2133 Series User's Guide