Draytek Vigor2133 User Manual page 650

remoteip
<Remote_Client_IP_Address
>
peer <Peer_ID>
naming <pass/block>
multicastvpn <pass/block>
prekey <on/off>
assignkey <Pre_Shared_Key>
digsig <on/off>
ipsec <Method> <on/off>
localid <Local_ID>
E x a m p l
E x a m p
> vpn dinset 1
Dial-in profile index 1
Profile Name: ???
Status: Deactive
Mobile OTP: Disabled
Password:
Idle Timeout: 300 sec
> vpn dinset 1 on
% set profile active
> vpn dinset 1 motp on
% Enable Mobile OTP mode!>
> vpn dinset 1 pin_secret 1234 e759bb6f0e94c7ab4fe6
> vpn dinset 1
Dial-in profile index 1
Profile Name: ???
638
off: disable.
It means to assign the IP address for the remote client.
It means to assign the peer ID for such profile.
Pass – Click it to have an inquiry for data transmission between the
hosts located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on both
sides of VPN Tunnel in connecting, it can block data transmission of
Netbios Naming Packet inside the tunnel.
Pass –Let multicast packets pass through the router.
Block – This is default setting. It can let multicast packets be
blocked by the router.
It means to enable/disable the pre-shared key for IKE
authentication method.
on: enable
off: disable.
Assign the pre-shared key.
Pre_Shared_Key – Type a string.
Enable /disable the function of Digital Signature (X.509) for IKE
authentication method.
Set the IPsec security medthod for the specified VPN profile.
Method - 0:Medium(AH) High(ESP), 1:DES, 2:3DES, 3:AES
on / off - enable / disable.
Assign a local ID to be used for Dial-in setting in the LAN-to-LAN
Profile setup.
Local_ID – Type a string.
e
l e
Vigor2133 Series User's Guide