Draytek Vigor2133 User Manual page 597

-n <name>
-a
-e <no>
-d <no>
-m <mode>
-l <addr>
-r <addr>
-p <DSCP id>
-s <Service type>
-S <d/s>
-V <1/2/3>
[...]
E x a m p l
E x a m p
> qos class -c 2 -n draytek -a -m 1 -l 192.168.1.50:192.168.1.80
Following setting will set in the class2
class 2 name set to draytek
Add a rule in class2
Class2 the 1 rule enabled
Set local address type to Range, 192.168.1.50:192.168.1.80
Vigor2133 Series User's Guide
class 1.
It means to type a name for the class.
It means to add rule for specified class.
It means to edit specified rule.
<no>: type the index number for the rule.
It means to delete specified rule.
<no>: type the index number for the rule.
It means to enable or disable the specified rule.
0: disable,
1: enable
Set the local address.
Addr1 – It means Single address. Please specify the IP address
directly, for example, "-l 172.16.3.9".
addr1:addr2 – It means Range address. Please specify the IP
addresses, for example, "-l 172.16.3.9: 172.16.3.50."
addr1:subnet – It means the subnet address with start IP address.
Please type the subnet and the IP address, for example, "-l
172.16.3.9:255.255.0.0".0
any – It means Any address. Simple type "-l" to specify any address
for this command.
Set the remote address.
addr1 – It means Single address. Please specify the IP address
directly, for example, "-l 172.16.3.9".
addr1:addr2 – It means Range address. Please specify the IP
addresses, for example, "-l 172.16.3.9: 172.16.3.50."
addr1:subnet – It means the subnet address with start IP address.
Please type the subnet and the IP address, for example, "-l
172.16.3.9:255.255.0.0".0
any – It means Any address. Simple type "-l" to specify any address
for this command.
Specify the ID.
Specify the service type by typing the number. The available types
are listed as below:
1:ANY 2:DNS 3:FTP 4:GRE 5:H.323
6:HTTP 7:HTTPS 8:IKE 9:IPSEC-AH 10:IPSEC-ESP
11:IRC 12:L2TP 13:NEWS 14:NFS 15:NNTP
16:PING 17:POP3 18:PPTP 19:REAL-AUDIO 20:RTSP
21:SFTP 22:SIP 23:SMTP 24:SNMP 25:SNMP-TRAPS
26:SQL-NET 27:SSH 28:SYSLOG 29:TELNET 30:TFTP
Show the content for specified DSCP ID/Service type.
Show the rule in the specified class.
It means that you can type in several commands in one line.
e
l e
585