Draytek Vigor2133 User Manual page 424

Address Type
MAC Address
Start IP Address
End IP Address
Subnet Mask
Invert Selection
4. After finishing all the settings here, please click OK to save the configuration. Below is
an example of IP objects settings.
412
Determine the address type for the IP address.
Select Single Address if this object contains one IP address
only.
Select Range Address if this object contains several IPs
within a range.
Select Subnet Address if this object contains one subnet for
IP address.
Select Any Address if this object contains any IP address.
Select Mac Address if this object contains Mac address.
Type the MAC address of the network card which will be
controlled.
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
Type the subnet mask if the Subnet Address type is selected.
If it is checked, all the IP addresses except the ones listed
above will be applied later while it is chosen.
Vigor2133 Series User's Guide