AT&T SYSTEM 25 User Manual page 41

You can also make inside calls using the Direct Station
Selection and Repertory Dialing features, which are covered
later in this guide.
Placing an Outside Call from an Idle Console
1. Lift the handset.
• The green light next to the selected <LOOP>
button turns on.
• Dial tone is supplied.
2. Dial the full number of the outside destination,
including a facility access code or the ARS access
code.
or
Press a <FACILITY> button to get into a pooled trunk
group; then dial the outside number. (If a trunk is not
available, you can activate a Busy-to-idle Reminder by
hanging up and then pressing the <FACILITY> button
again; your terminal will ring once when a trunk
becomes free.)
You can also make outside calls using the Repertory Dialing
and Speed Dialing features, which are covered later in this
guide.
Placing a Call from a Console When an Incoming Call Is
Ringing
1. Just before lifting the handset, press an idle <LOOP>
button.
• The red l-use light moves to the selected button.
2. Lift the handset.
• The green light next to this <LOOP> button
turns on.
Placing Calls (Contd)
Continued
3 7