Table of Contents
Advertisement
4.8.6.d
LUBRICATING THE PROPELLER SHAFTS
Carry out this operation with the machine parked on a level
q
surface, the work equipment resting on the ground and the
engine off.
The propeller shafts must be lubricated after thoroughly cleaning
the grease nipples, by applying the grease pump filled with the
prescribed grease.
(See "4.3 FUEL, COOLANT AND LUBRICANTS" and "4.5.1
LUBRICATION DIAGRAM").
Once the lubrication procedure has been carried out, make sure
that all the points have been lubricated and remove the used
grease that may have spread out of the joints.
IMPORTANTE
If the machine is used in difficult conditions, carry out this
q
operation more frequently than usual.
AVVERTENZA
MAINTENANCE PROCEDURES
RWAA9040
RKAB3900
RKAB3910
RWAA9070
207
Advertisement
Chapters
Table of Contents
