Table of Contents
Advertisement
4.8.1.n
CHECKING AND ADJUSTING THE
STABILIZER SLACK
When leaving the operator's seat during the adjustment of
q
the guides, remove the ignition key.
1 - Position the machine on level ground, raise the stabilizers
completely, engage all the safety locks and stop the engine.
2 - Push and pull each stabilizer manually and make sure that
the slack between the mobile rod (1) and the adjusting
element (2) is included between 0.5 and 1.0 mm.
If the slack exceeds the values indicated, loosen the screws
(3), remove the adjusting plate (4) and remove one or more
washers (5) from both the adjusting points, according to the
needs.
Once they have been removed, the washers (5) must be
positioned again between the adjusting plate (4) and the
screws (3).
During the adjustment, check the condition of the adjusting
element (2) and change it immediately if it is excessively
worn.
After reassembling the washers (5), plate (4) and fastening
screws (3) in this order, check if the slack is within the
prescribed values.
AVVERTENZA
MAINTENANCE PROCEDURES
3
4
4
3
3
5
2
RKA14210
RKA14220
3
4
5
1
RWA17270
199
Advertisement
Chapters
Table of Contents
