Genie Z-30/20N Service Manual page 77

June 2011
REV A
52 Attach a lifting strap from an overhead crane to
the mid-pivot for support.
53 Remove the pin retaining fasteners from the
mid-pivot to the lower secondary compression
arm pivot pins. Use a slide hammer and
remove the pins. Lower the compression arms
down.
54 Remove the pin retaining fasteners from the
mid-pivot to the lower secondary boom pivot
pin. Use a soft metal drift to remove the pins.
55 Remove the mid-pivot from the machine.
Crushing hazard. The mid-pivot
could become unbalanced and fall
when removed from the machine if
not properly supported by the
overhead crane.
56 Remove the secondary boom drive speed limit
switch (LS4) mounted to the turntable riser on
the ground controls side. Do not disconnect the
wiring.
57 Attach a lifting strap from an overhead crane to
the ground control side lower secondary boom
compression arm.
58 Remove the pin retaining fastener from the
lower secondary boom compression arm to
turntable riser pivot pin.
59 Use a slide hammer and remove the pin.
Remove the compression arm from the
machine. Repeat for the hydraulic tank side
lower secondary boom compression arm.
Crushing hazard. The lower
secondary compression arm could
become unbalanced and fall when
removed from the machine if not
properly supported by the overhead
crane.
Part No. 139378 Z-30/20N • Z-30/20N RJ • Z-34/22 • Z-34/22N
Section 4 • Repair Procedures
SECONDARY BOOM COMPONENTS
60 Attach a lifting strap from an overhead crane to
the lower secondary boom.
61 Remove the pin retaining fastener from the lower
secondary boom to turntable riser pivot pin. Use
a soft metal drift to remove the pin.
62 Remove the lower secondary boom from the
machine.
Crushing hazard. The lower
secondary boom could become
unbalanced and fall when
removed from the machine if not
properly supported by the
overhead crane.
4 - 27