Hydraulic Oil Specifications; Hydraulic Component Specifications - Genie Z-30/20N Service Manual

June 2011
REV C

Hydraulic Oil Specifications

Hydraulic Oil Specifications
Hydraulic oil type Chevron Rando HD equivalent
Viscosity grade
Viscosity index
Cleanliness level, minimum
Water content, maximum
Chevron Rando HD oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation, corrosion inhibition, seal conditioning, and
foam and aeration suppression properties.
Optional fluids
Biodegradable
Fire resistant
Mineral based
Continued use of Chevron
Aviation A hydraulic fluid when
ambient temperatures are
consistently above 32°F / 0°C may
result in component damage.
Note: Use Chevron Aviation A hydraulic fluid when
ambient temperatures are consistently below
0°F / -18°C.
Note: Use Shell Tellus T46 hydraulic oil when oil
temperatures consistently exceed 205°F / 96°C.
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult the Genie
Industries Service Department before use.
Part No. 139378
Multi-viscosity
200
15/13
200 ppm
Petro Canada Environ MV46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydrolube HP-5046
Quintolubric 822
Shell Tellus T32
Shell Tellus T46
Chevron Aviation A
Z-30/20N • Z-30/20N RJ • Z-34/22 • Z-34/22N
Hydraulic Component
Specifications
Function pump
Type: Fixed displacement gear pump
Displacement
Flow rate @
2800 psi / 172 bar
Hydraulic tank
return filter
Function manifold
System relief valve pressure,
Z-30/20N and Z-30/20N RJ
System relief valve pressure,
Z-34/22 and Z-34/22N
Primary boom down relief pressure
Secondary boom down relief pressure
Primary boom extend relief pressure
Models with rotating jib
Turntable rotate relief pressure
Auxiliary pump
Type: Fixed displacement gear pump
Displacement
Continuous improvement of our products is a
Genie policy. Product specifications are
subject to change without notice.
Section 2 • Specifications
SPECIFICATIONS
0.183 cu in
3 cc
2.1 gpm
7.9 L/min
10 micron with
25 psi / 1.7 bar bypass
2800 psi
193 bar
3200 psi
221 bar
1600 psi
110 bar
1600 psi
110 bar
1800 psi
124 bar
1100 psi
76 bar
0.3 gpm
1.14 L/min
2 - 3