Performance Specifications; Hydraulic Oil Specifications - Genie S-45 XC Service And Repair Manual

Service and Repair Manual
Specifications

Performance Specifications

Drive speeds,
2WD and 4WD
Stowed
Raised or extended
Drive speeds,
TraX option
Stowed
Raised or extended
Gradeability
Braking distance, maximum
High range on paved surface
Boom function speeds, maximum
from platform controls
Jib boom up, S-45 models
Jib boom down, S-45 models
Platform level
(10° range of motion)
Boom up
Boom down
Boom extend
Boom retract
Turntable rotate, 360°
Stowed
Turntable rotate, 360°
Not stowed
For operational specifications, refer to the
Operator's Manual.
2
40 ft / 6.8 - 7.4 sec
12.2 m / 6.8 - 7.4 sec
40 ft / 40 - 45 sec
12.2 m / 40 - 45 sec
40 ft / 9 - 11 sec
12.2 m / 9 - 11 sec
40 ft / 40 - 45 sec
12.2 m / 40 - 45 sec
See Operator's Manual
3 - 4 ft
0.9 - 1.2 m
48 - 53 seconds
28 - 33 seconds
3 - 5 seconds
50 - 60 seconds
50 - 60 seconds
30 - 60 seconds
15 - 35 seconds
70 - 100 seconds
120 - 140 seconds
S-40 XC • S-45 XC • S-40 TraX • S-45 TraX

Hydraulic Oil Specifications

Hydraulic Fluid Specifications
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Cleanliness level,
minimum
Water content,
maximum
Recommended Hydraulic Fluid
Hydraulic oil type
Viscosity grade
Viscosity index
Optional Hydraulic Fluids
Mineral based
Biodegradable
Fire resistant
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie
Product Support before use.
Optional fluids may not have
the same hydraulic lifespan and
may result in component
damage.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond it's
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.
July 2019
ISO 15/13
250 ppm
Chevron Rando HD Premium
Shell Tellus S2 V 32
Shell Tellus S2 V 46
Shell Tellus S4 VX 32 Shell
Shell Donax TG (Dexron III)
Chevron 5606A
Petro Canada Environ MV 46
UCON Hydrolube HP-5046
Part No. 1286829GT
32
200