Initialization To Default Settings; Manual Initialization - Trane TR200 Instruction Manual

How to Operate the Frequency Converter

Initialization to Default Settings

There are two ways to initialize the frequency converter to default: Recommended initialization and manual
initialization.
Please be aware that they have different impact according to the below description.
Recommended initialization (via par. 14-22
tion Mode)
1. Select par. 14-22 Operation Mode
2. Press [OK]
3. Select "Initialization"
4. Press [OK]
5. Remove power to unit and wait for display to turn
off.
6. Reconnect power and the frequency converter is
reset. Note that first start-up takes a few more
seconds
7. Press [Reset]
Parameters selected in par. 0-25

Manual initialization

When carrying out manual initialization, serial communication, RFI filter settings and fault log settings are reset.
Removes parameters selected in par. 0-25
1. Disconnect from mains and wait until the dis-
play turns off.
2a. Press [Status] - [Main Menu] - [OK] at the
same time while power up for Graphical LCP
(GLCP)
3. Release the keys after 5 s
4. The frequency converter is now programd ac-
cording to default settings
5-12
Opera-
My Personal Menu, will stay present, with default factory setting.
My Personal Menu.
Par. 14-22 Operation Mode
Par. 14-50 RFI Filter
Par. 8-30 Protocol
Par. 8-31 Address
Par. 8-32 Baud Rate
Par. 8-35 Minimum Response Delay
Par. 8-36 Max Response Delay
Par. 8-37 Maximum Inter-Char Delay
Par. 15-00 Operating Hours
Volt's
Par. 15-20 Historic Log: Event
toric Log: Time
Par. 15-30 Alarm Log: Error Code
par. 15-32 Alarm Log: Time
This parameter initializes all except:
Par. 15-00 Operating Hours
Par. 15-03 Power Up's
Par. 15-04 Over Temp's
Par. 15-05 Over Volt's
initializes all except:
to par. 15-05 Over
to par. 15-22 His-
to
BAS-SVX19C-EN