Adjusting The Throttle Cable - Yamaha 55DEHD Service Manual

CHK
ADJ
3. Remove the control link rod 2, and then
measure the length a of the link.
a
4. Adjust the length a if out of specification.
Length a (reference data):
71 mm (2.79 in)
5. Install the control link rod 2.
6. Check that the ignition timing to the spec-
ified position at full retard.
Specified position (full retard):
BTDC 2°
NOTE:
9 To check the ignition timing, refer to page
3-9.
9 To check the timing stopper, refer to page
3-11.
7. Install the throttle link rod and the throttle
cable.
3-7
Periodic check and adjustment
2
68830030

Adjusting the throttle cable

1. Loosen the locknut 1, remove the pin 2
and then disconnect the throttle cable
joint 3.
3
1
2. Set the throttle grip or remote control
lever to the fully closed position.
3. Adjust the position of the throttle cable
joint 3 until its hole aligned with the set
pin 4 on control lever.
4
3
2
68830160
N
68830550
3
68830170
a
61U30320
6885J11