Removing And Replacing The Glass Panel - Rinnai Evolve 952 Series Installation Manual

Removing and replacing the glass panel

Before the burn media can be installed into the combustion chamber, the glass panel needs to be
removed. Remove the four retaining screws—two at the top and two at the bottom. When replacing
tighten all four screws and then back off by quarter of a turn. If the glass panel is screwed too tight,
the panel will bow and the spring release mechanism won't work properly.
The glass panel needs to be replaced after installing the burn media and before commissioning.
Front panel of the Evolve showing the four screw positions for removing and
replacing the glass panel
Evolve 952/1252 Installation Guide: 13115-E 05-19 | 17