Job Separation - Ricoh Priport JP8000 Operating Instructions Manual

Job Separation

The print on the top of each print set in the paper delivery tray is pulled by the
job separator. This function is useful when you make two or more print sets.
R CAUTION:
• While printing, do not touch the belt at the end of the paper delivery tray or
the job separator. Otherwise, an injury might occur.
Limitation
❒ In Job Separation mode, the following limitations apply.
❖ ❖ ❖ ❖ Metric version
Minimum paper size
Length: 210mm
Width: 128mm
❖ ❖ ❖ ❖ Inch version
Minimum paper size
Length: 8.3"
Width: 5.1"
Note
❒ When you use thin paper, it is not recommended to use Job Separation mode.
The job separator might tear the paper.
❒ If the job separator touches the print image, prints might be marked. In this
case, it is not recommended to use Job Separation mode.
❒ When you do not use Job Separation mode, you can select the machine con-
dition after each print set is fed out to the paper delivery tray with the user
tools. See "Auto Class" on p.146 "4. Mode Setting".
❒ If there are less than 10 sheets of paper in the paper delivery tray, the machine
may not be able to use Job Separation mode.
GRJOBS0E
Maximum paper weight
2
127.9g/m
Maximum paper weight
34 lb
Job Separation
Paper delivery tray capacity
2
600 sheets (64g/m )
Paper delivery tray capacity
600 sheets (17 lb)
1
79