Energy Saver Mode - Ricoh Priport JP8000 Operating Instructions Manual

Operation

Energy Saver Mode

If you do not operate the machine for a certain period the machine can enter
Quality Standby mode to remove ink from inside the ink drum. The machine can
1
then enter Energy Saver mode.
You can press the {Clear Modes/Energy Saver} key to cancel Energy Saver mode
and the machine returns to the ready condition.
If you press the {Clear Modes/Energy Saver} key for more than three seconds, the
machine will enter Quality Standby mode to remove ink from inside the ink
drum then it will enter Energy Saver mode.
Quality Standby mode helps to reduce excess ink when printing.
It reduces recovery time from Energy Saver mode.
Energy Saver mode uses less electricity.
See "Energy Saving" ⇒ P.137 "1. System".
Note
❒ You can change the setting so that the machine does not enter Quality Stand-
by mode. ⇒ P.22 "Energy Saver Mode".
❒ Quality Standby mode lasts for a few seconds.
❒ You can change the time the machine waits before Energy Saver mode starts.
⇒ P.22 "Energy Saver Mode".
❒ The machine will not automatically enter Energy Saver mode in the following
cases:
• If there is no ink
• If the originals or paper are jammed
• If the machine is making master or printing
• If the machine is printing the second page of a combined print job
• If the machine is loading original images in memory
• If there is no paper
• If there is no master
• If the paper delivery box is full
• If there are originals still on the machine
• If the cover open message is displayed
• If the settings have been reset to their defaults
• If the User Code entry screen is displayed
22