Erasing Center And Edge Margins - Ricoh Priport JP8000 Operating Instructions Manual

Erasing Center and Edge Margins

When printing from thick books, or
similar originals, the binding margin
at the center and the edges might ap-
pear on prints. To prevent this, per-
form the following steps.
Important
❒ Be sure to keep the platen cover at
an angle of at least 25 degrees with
the exposure glass.
❒ If you do not press hard on the
book while it is scanned, the mar-
gin at the center might no be
erased completely.
Note
❒ If your originals have solid images
at the edges, the machine might
recognize the solid images as shad-
ows and not copy them. In this
case, use Edge Erase mode so that
only the shadows are not copied.
⇒ P.40 "Edge Erase"
A
Set the book on the exposure
glass.
Erasing Center and Edge Margins
B
Keep the platen cover at an angle
of at least 25 degrees with the ex-
posure glass.
C
Press the { { { { Start} } } } key.
Note
❒ Press hard on the book with
your hand while it is scanned.
D
Check the image position of the
trial or proof print.
Note
❒ If the image position is not cor-
rect, adjust it using the [Image
= ] key (⇒ P.23 "Adjusting the = = =
Position of Printed Images").
E
Make your prints.
1
39