If You Cannot Make Prints as You Want
Problem
Misfeeds occur frequently.
When you try to set several
functions at a time, you can-
not set some functions.
Parts of the image are not
printed in Edge Erase mode.
Prints are blank or parts of the
image are not printed.
2nd printing with another
drum is unsatisfactory.
An uneven solid image ap-
pears.
Combine Originals Mode
Problem
Prints are blank or parts of the
image are not printed.
Print image is not correct.
Cause
Improper paper type is select-
ed.
Some functions cannot be
used together.
Erase margin is too wide.
Edge margins of original are
too narrow.
The paper feed side plates are
not set correctly.
The 1st print image is still wet. Wait until the 1st image be-
Large solid image wrinkles
the master.
Cause
Original size and direction are
not correct.
Original set order is not cor-
rect.
If You Cannot Make Prints as You Want
Action
Select proper paper type. ⇒
P.41 "Printing onto Various
Kinds of Paper".
⇒ P.133 "Combination Chart".
Set a narrower erase margin
with the user tools. ⇒ P.152
"3-11 Margin Erase Area".
Make sure that the paper feed
side plates touch the paper
lightly and the proper paper
size is displayed in the panel
display.
comes dry.
Increase the print speed or se-
lect photo mode.
Action
You cannot use originals of
different sizes and directions
in Combine Originals mode.
Use originals of same size and
direction.
Place originals face up into the
optional document feeder.
The first original should be on
the top.
Place original face down on
the exposure glass. The first
original should be set first.
5
167