Ricoh AP1400/AP2000 Operating Instructions Manual page 265

2. Double-click on the BOOTPL32 icon to start the program.
3. Pull down the Admin menu to Configure option.
4. Enter the IP address that you want to assign to the Network Interface Board, its Subnet
Mask (make sure it matches what you are using on your subnet), Default Gateway (your
router's IP address), and the MAC address of the Network Interface Board (Hardware
Address, listed on the Status sheet as Ethernet Address). Use colons as delimiters as
shown on the status sheet rather than the dashes that Windows uses. (eg.
00:40:AF:12:34:23)
5. Click on [Go].
6. Wait about five minutes. The Network Interface Board should recycle and produce a
status sheet showing the IP parameters you have just entered.
7. Pull down Admin menu to Verify. You should get a message back stating that the Unit is
Active. If you do not get this message, check that TCP/IP is enabled on the status sheet.
8. When you get a response that your unit is active, you should be able to ping and Telnet
to the Network Interface Board.
7.1.3.4 Setting up IP and lpr Parameters
The Network Interface Board provides for a setup connection via the standard Telnet port. To
be able to make changes to a unit at factory default settings, you must logon as sysadm.
The default password is also "sysadm" (this password can be changed from the Telnet
utility). See 7.6 Running Telnet, for instructions on using Telnet.
1. Telnet to the Network Interface Board (the login and password are both "sysadm").
2. Turn off the protocols that you are not utilizing (option 3).
3. Setup the subnet mask and default gateway for the Network Interface Board if applicable
(option 1).
4. Exit, Save, and Reset the Network Interface Board.
You can also use "User Tools" menu on the operator panel, the HTML pages accessible via
MAP or a Web Browser to set up lpr. The password to change parameters with the HTML
pages is the same as the Telnet password.
7.1.3.5 Setting up lpr on the Workstation
The following procedure is used to set up the lpr spooler on the Windows NT server.
1. Open Control Panel.
2. Go to Printers.
3. Choose Printer Menu.
4. Choose Create Printer.
5. Enter a printer name (For example, lprprinter).
6. Select the proper printer driver.
7. Enter a description.
This is optional.
Chapter 7 - 8