Cleaning The Printer; Cleaning The Friction Pad - Ricoh AP1400/AP2000 Operating Instructions Manual

Cleaning the Printer

Cleaning the Friction Pad

If the friction pad becomes dirty, mis-
feeds or multi-feeds of paper might
occur. In this case, clean the pad as
follows:
Type 1 printer
Note
Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
A
Pull the paper tray until it stops.
After that, lift it slightly, then pull
it out of the printer.
Note
Do not touch the three white
pins on the right front side of
the printer.
B
Place the tray on a flat surface. Re-
move paper from the paper tray.
C
Clean the friction pad (gray or
brown part) with a soft damp
cloth. After wiping it with a damp
cloth, wipe it with a dry cloth to
remove the water.
Important
Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
D
Load paper with the print side up
into the paper tray. While lifting
the front side of the tray, insert
the paper tray into the printer.
Then push it until it stops.
TS3Y270E
Note
If misfeeds or multi-feeds of pa-
per occur after cleaning the fric-
tion pad, contact your sales or
service representative.
Follow the same procedure to
clean the friction pad of the op-
tional tray and the envelope
feeder.
Cleaning the Printer
TS3Y280E
TS3Y100E
117
10